pieces, circular washers, hot-dip galvanized, 24 mm, Type 1 ASTM F. M, dated ______. (2) pieces, beveled washers, 22 mm, Type 3,. ASTM, F M. Designation: F M – 93 (Reapproved ) METRIC. Standard Specification for. Hardened Steel Washers [Metric]’ This standard is issued under the fixed. Designation: F M – 93 (Reapproved ) METRIC Standard Specification for ‘This specification is under the jurisdiction of ASTM Committee F on.
|Country:||Moldova, Republic of|
|Published (Last):||11 June 2015|
|PDF File Size:||17.74 Mb|
|ePub File Size:||20.11 Mb|
|Price:||Free* [*Free Regsitration Required]|
WASHER FM SILVER ZINC ASTM 10MM ( )
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. The atmospheric corrosion resistance of these steels is substantially better than that of carbon steel with or without copper addition. Steels to be used to manufacture the washers shall be produced by the open-hearth, basic-oxygen, or electric-furnace process. Each asrm and style of washer shall be suitably sampled, and should f4336m to specified values of chemical composition, Rockwell hardness, inside and outside diameter, thickness, and clipped width.
Combining values from the two systems may result in non-conformance with the standard. When properly exposed to the atmosphere, these steels can be used bare uncoated for many applications. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations f4366m to use.
The types of washers covered here are: Stay on Page Continue to Compass. No other units of measurement are astmm in this standard. This specification covers the chemical, mechanical, and dimensional requirements for hardened steel washers for use with fasteners having nominal thread diameters of M12 through M These washers are intended for general-purpose mechanical and structural use with bolts, nuts, studs, and other internally and externally threaded fasteners.
WASHER F436M SILVER ZINC ASTM 10MM
These washers are intended for general-purpose mechanical and structural use with bolts, nuts, studs, and other internally and externally threaded fasteners. Note 1—This specification is the metric counterpart of Specification F The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. It is the responsibility of the user of this standard to establish appropriate safety and health practices atsm determine the applicability of regulatory limitations prior to use.
Link to Active This link will always route to the satm Active version of the standard.
Moreover, the styles of washers covered here are: Type 1 — washers made of carbon steel; and Type 3 — washers made of weathering steel. ASTM does not give any warranty sstm or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
Work Item s – proposed revisions of this standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.
This specification axtm the chemical, mechanical, and dimensional requirements for metric hardened steel washers for use with fasteners having nominal thread diameters M12 through M Historical Version s – view previous versions of standard.
v436m Link to Active This link will always route to the current Active version of the standard. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
This abstract is a brief summary of the referenced standard.